Lectrosonics BIAST DC Power Module for Coaxial Antenna Cable

The BIAS T is used to apply DC power to a coaxial antenna line for remotely powering the UFM230 filter/amp. The DC power applied to the BIAS T (9 to 16 VDC) appears on the input port of the BIAS T to power the UFM230 through the coaxial cable, but is isolated from the output port so it will not be applied to the input of the receiver.

The BIAS T is normally placed near the receiver being fed by the coaxial cable, where power is available. The UFM230 filter/amp and antenna are placed at the opposite end of the coaxial cable, close to the antenna.

• Power supply (not included with BiasT)
  
• 110V AC input
  
• 12V DC regulated output required for powering the BIAS T
  (CH20, DCR12/A8U and DCR12/A4U will work.)